NEC VERSA DOCKING STATION 4000 - Page 6

iv Contents
Running the Setup Utility..................................... 3-4
Docking Station 4000 Setup Software.................. 3-7
Choosing a Configuration ............................... 3-7
Using the Audio Switcher Utility..................... 3-8
Using DOS-Based Programs........................... 3-11
Changing the Volume.................................. 3-11
Changing IRQ and DMA Settings............... 3-12
Option Configuration........................................... 3-14
Drivers................................................................ 3-14
Multiple Configuration Systems...................... 3-15
Single Configuration Systems ......................... 3-15
Creating a Start-Up Diskette....................... 3-16
Creating a Second Configuration File.......... 3-16
Switching between Configurations............... 3-17
The SCSI Configuration Driver ...................... 3-18
Using the Driver ......................................... 3-18
Modifying the CONFIG.SYS File............... 3-19
Quick Start............................................................... 3-22
4 Adding Options
Cover Removal......................................................... 4-2
Cover Replacement................................................... 4-4
Expansion Boards..................................................... 4-6
Precautions.......................................................... 4-7
Slot Locations ..................................................... 4-7
Installation .......................................................... 4-7
Removal.............................................................. 4-12
Data Storage Devices ............................................... 4-14
Preparing the Drive.............................................. 4-14
Installing Drives in the Front Bay......................... 4-15
Removing the Drive Cage ............................... 4-15
Attaching the Drive to the Drive Cage............. 4-17
Attaching the Cables....................................... 4-19
Finishing Up................................................... 4-32
Hard Disk Drives................................................. 4-34
Preparing the Hard Disk Drive........................ 4-35
Specifying Master and Slave Drives................ 4-36