NEC Versa LX - External Audio Options

Using External Devices 5-9
Note:
The default TV Out setting is for NTSC
transmission. The U.S. and Japan use the default
NTSC signal; Hong Kong and most European
countries use the PAL signal. If you require the PAL
setting, use the Advanced CMOS Setup section of
the BIOS setup utility to change the setting.
The NEC Versa does not support the SECAM
signals used in some countries.
External Audio Options
The NEC Versa comes equipped with built-in audio ports that let you
record and play sound.
Connect audio jacks, like a microphone, headphones, or external
speakers to the audio ports as follows.
1.
Locate the audio port that you want to use.
2.
Plug the jack into the appropriate port on the right side of the NEC
Versa.
Audio ports
A
– Volume Control
B
– Headphones
C
– Line In
D
– External Microphone