7-14
Solving System Problems
9.
Press
Enter
, click Reboot, or press
Alt-R
to reboot your system.
A series of hardware detection screens display, the system reboots,
and the Windows Setup screen appears. Follow the on-screen
instructions to set up Windows.
You are required to reenter your Microsoft license number.
Windows NT Recovery CDs
Your Windows NT system ships with two Product Recovery CDs for
Microsoft Windows NT.
!
The 1st CD, labeled Product Recovery CD (1 of 2), contains a mirror
image of the Windows NT system as it shipped from the factory.
Only use this CD as a last resort as it removes or replaces existing
files, which results in data loss.
!
The 2nd CD, labeled Product Recovery CD (2 of 2), contains a subset
of the Microsoft Windows NT 4.0 Workstation software. Whenever
you install an additional Windows NT component, the following
Windows NT Setup screen appears.
Setup needs to copy some Windows NT files.
Setup will look for the files in the location specified below.
If you want Setup to look in a different place, type the new location.
When the location is correct, click Continue.
When prompted with this screen, insert the Product Recovery CD (2
of 2) for Microsoft Windows NT, enter
F
:\I386
(where F refers to the
letter assigned to the CD-ROM drive), and click on Continue. Then
follow the on-screen instructions.
To Next Page
Loading...
