NEC Versa LX - Installing a Device in the VersaBay III

Using the Hardware 4-13
6.
Pull the device out of the system.
Note:
If you release the latch before completely
removing the device, the device casing catches on
the inside of the latch.
Releasing the device
Installing a Device in the VersaBay III
Use the following steps to install a device in the VersaBay III.
Your system must be in a suspended state to use the utility, or powered
off, before removing or inserting devices in the VersaBay III.
1.
Use the NEC VersaBay Swapping Utility to put your system into a
suspended state, or power off the system.
2.
Close the LCD panel and turn the system upside down.