Necchi C360 - Inserting the Bobbin

9
Inserting the bobbin
n
Attention
Turn the power switch to off ("O").
When inserting or removing the bobbin, the
needle and the presser foot must be fully
raised.
Open the bobbin cover by pushing the release
button to the right.
①
Release button
Insert the bobbin in the bobbin case with
the thread running in a counter-clockwise
direction (arrow).
Pull the thread through the slit (A).
With a nger hold gently on top of the bobbin,
please follow the arrow markings and draw
the thread into the bobbin thread guide from
(A) to (B).
Pull the thread at the arrow markings into the
stitch plate thread guide from (B) to (C).
To cut off excessive thread, pull it back to the
cutter at point (C).
Close the bobbin cover.
1