© by N&W GLOBAL VENDING S.p.A. 13 12 2008 3335 00
POWER ON
electronics will:
-
-
-
release jaws after having closed the jaws (the models
with m u l t i m a x
initialise - s o f t v E n d in the initial position (models with
s o f t v E n d
software release -
presence of the photocells intended to detect the dis- -
pensing cycle
-
presence of the device intended to prevent the dis- -
pensing compartment from opening
-
The cooling unit is dimensioned to guarantee 7°C at
-
ter having completed the load cycle if the machine
had already achieved its steady state.
time, wait for the steady-state temperature to be
reached before inserting the products.
The manufacturer will disclaim all responsibility
for any damage caused by the inobservance of the
precautions mentioned above.
OPERATING TEMPERATURE
-
CLEANING AT REGULAR INTERVALS
-
Attention !!!
It is anyway forbidden to direct any water jet
against the machine
CLEANING THE VENTILATION GRIDS OF
THE COOLING SYSTEM
Clean the ventilation grid of the cooling system at least
-
-
extract the aspiration grid -
after having cleaned the grids, re-assemble everything -
by acting in the reverse order
Attention!!!
It is forbidden to direct any water jet against the
machine.
-
icing.
-
tactness and its compliance with the rules in force
at least once a year.
Fig. 17
Dispensing compartment1-
Aspiration grid2-
Feet cover3-
To Next Page
Loading...
Need help?
General
