© by N&W GLOBAL VENDING S.p.A. 12 12 2008 3335 00
LOADING SANDWICH TRAYS
Some models can have sandwich trays,
conceived for dispensing sandwiches ONLY.
This area can be recognised by the plates on the divid-
To dispense sandwiches, it is necessary to provide the
dispenser with the tray that can be recognised by the
Sandwiches shall be loaded with the lower edge being
Attention !!!
LOADING MULTIMAX TRAYS
Some models can have m u l t i m a x trays
for dispensing bottles and cans ONLY-
m u l t i m a x
since they can provide for greater capacity than spiral
To load the compartments, act as follows:
-
Attention: to extract, avoid seizing the tray by the
but use the supplied handle by coupling it beneath
the tray.
-
compartment
load the bottles or cans vertically: start from the bottom -
of the compartment to reach the jaws
Cans and bottles shall be easily insertable into the
compartments. Prevent the products from getting
-
-
reinsert the tray into the machine and close the door -
-
of m u l t i m a x trays”
Fig. 16
Product anti-turn-over partition1-
Jaws2-
Fig. 15
Bridge regulation holes1-
Retainer bridge2-
Tray for sandwiches3-
Right sandwich loading4-
False sandwich loading5-
To Next Page
Loading...
