Tucker GmbH, Mail / Post: Max-Eyth-Str.1, 35394 Gießen, Germany
Stud welding unit N800i
As of 24.08.2021
Manual part number: BE 1227
Keeps the lifted after the weld for 5 se- conds for the purpose of
troubleshoo- ting applications.
Delay from the time the gun coil is en- ergized to the time the pilot arc is
tur- ned on.
Enable this to deliver constant energy to a weld referenced by a target
weld (stored as a preset).
Pulse Cleaning
Contaminant to be
cleaned
Zinc or Galva-
nized
to Primer
Paint, Oil
or
Oxide
Use this function to designate how the pulse cleaning function
determines ab- orts pulsing and begins the main arc. Select
‘Zinc\Galvanized’ to start the main arc when sensed voltage is above the
threshold set in F38
Enable this to make the gun select pre- sets based on the gun trigger as
an in- put. Press and hold the gun trigger 2 seconds beyond the lift
check to incre- ment presets within bank.
Increase the number of pecks to per- form a series of lift plunge actions
prior to the weld. The inventer will attempts a weld as soon as it detects
contact between the stud and work piece or af- ter the number of pecks
is performed. When zero, pecking is disabled.
To Next Page
Loading...
