Save after setting well the pick position of the feeder. Same way as in the file.
“Feed-box” setting
It is used to set the feed-box ID. E.g., if you insert the feed-box 2 in the port 1, then it need to set
the feed-box ID to be 2
“Peel Box”setting
“Peel box” is different from “Feed box”,the ID for peel box is corresponding to the port.For
example,no matter which “Peel box” you connect,the ID always be No.1.
Above setting can help set the serial number of the stack in power supply port on the machine,
See below fig.
To Next Page
Loading...