completely
— The nozzle was blocked
— The nozzle is damaged or has a crack
— The size issue of nozzle would cause air leakage or insufficient suction.
— The air hose is blocked or has a leakage problem, and even the pump has an issue.
b. Frequently throwing components. Some suggestions are listed below,
— Up-looking camera can’t take a clear picture of component due to brightness issue for
example.
— The size or shape isn’t aligned with that in “Footprint library”
— The size of nozzle is inappropriate or insufficient suction.
— The nozzle is damaged or blocked, and even has a crack
4.6. Continuous SMT production
Follow the SOP to start production
Notes
1.Do not touch the surface to board to avoid damaging the printed solder paste.
2.When the error message occurs, please checkout and solve it a.s.a.p.
3.Once reloading the component during production, pay attention to the model,specification,
polarity and direction of components.
To Next Page
Loading...