NeoDen 4 - 3. Procedure for making a programming file

To Next Page

To Previous Page

3. Procedure for making a programming

file

Note: The basic procedure of making a programming file for manual programming or direct PCB

file is similar, but there are two different parts: chip list and mark point setting. Please find the

detailed operation steps of the differences on relative page.

Start

Add a new file

Edit the file

2、Chip list

See P11

See P 17

See P11

See P13

See P10

1. PCB feed setting

3.Feeder setting

4.Panelized PCB first

chip setting

5.Mark point setting

Save

and

return

Select

file and

start

working