Prodigio service manual Version 1.0 en
40
REPAIRS
7 REPAIRS
These repair instructions
- are based on exploded drawings with position numbers combined with repair and
mounting tips,
- presuppose basic knowledge in repairing Nespresso coffee machines.
7.1 Safety instructions
7.2 Repair and mounting tips
These general advices are completed with specific repair tips in this chapter.
Additional information
The Prodigio coffee machine is shown for general repair procedures while the
Prodigio&milk coffee machine is shown solely for the repair resp. replacement of the
swivel arm with the Otter connector.
For components not mentioned in this repair chapter, refer to the chapter "Explosion
drawings and parts lists" on page 93.
Snap connections
Parts of the case and components of the coffee machine are connected screwless with
latches.
When loosening these latches, proceed with care and patience to avoid
causing any damage.
Designation of spare parts
The components in the following illustrations are indexed with position numbers.
See separate spare parts list for corresponding spare part numbers.
Electrostatic discharge (ESD) protection
The service technician must observe basic ESD protection measures when installing a
new MMI board or electronic module.
Risk of fatal electrical shock!
Mains voltage inside the coffee machine.
Disconnect the mains plug before disassembly - the coffee machine
must be free of voltage.
Danger of burns!
Hot parts and water under pressure inside the coffee machine
(thermoblock in particular).
Let coffee machine cool down before disassembly.
Only use original spare parts from your official supplier for maintenance
and repair work.
Position numbers are
subject to change
without notice.
To Next Page
Loading...
