Page 12
To enter the IP address:
1. Lift the telephone handset and dial ***2 (the IP address parameter code). The voice
prompt responds, “Please enter your IP address.”
2. Dial the numbers for the IP address you wish to enter on the telephone keypad. Use
the star key (*) to replace the periods in the address and end with the pound key (#).
For example, if you want to enter the IP address 192.168.172.19, you would enter
192*168*172*19# from your telephone keypad.
The voice prompt responds, “Your IP address is…” and repeats the address you
entered.
3. If the new address is correct, simply hang up the telephone. If the new address is
incorrect, hang up the telephone and repeat from step 1, above.
4. Reset the Net2Phone MAX 420 to activate the changes. To do this, power-off the unit,
wait 10 seconds, and turn it on again.
You are now ready to finish setting up the Net2Phone MAX 420 using the MAX Web
Manager. Proceed to Section 3, Logging In to the MAX Web Manager.
2.2.1.3 Entering a netmask address from a telephone keypad (MAX 420/430)
To enter a netmask address:
1. Lift the handset and dial ***3 (the netmask parameter code). The voice prompt
responds, “Please enter your netmask.”
2. Proceed as in step 2, above, entering the desired netmask address from the
telephone keypad.
The voice prompt responds, “Your netmask address is…” and repeats the address
you entered.
3. Proceed as in step 3, above.
4. Reset the Net2Phone MAX 420 as directed in Step 4 in Section 2.2.1.2, above.
The new netmask address is now in effect.
If you are using static IP addresses, you are now ready to finish setting up the Net2Phone
MAX 420 using the MAX Web Manager. Proceed to Section 3, Logging In to the MAX Web
Manager.
2.2.1.4 Re-enabling DHCP from a telephone keypad (MAX 420/430)
If you need to re-enable DHCP in the Net2Phone MAX 420, proceed as follows:
1. Lift the handset and dial ***4 (the enable DHCP parameter code). The voice prompt
announces, “DHCP is enabled now. Please press pound.”
2. Press the pound key (#).
DHCP is now enabled.
Net2Phone MAX 410/420/430 User GuideSection 2.2 –
Connecting to a LAN with Static IP Addresses
To Next Page
Loading...