Page 23
NOTES:
?? To receive MAX-to-MAX calls when multiple ports are sharing a single account, only one
of the ports sharing the account may have the Y selected.
?? Only one call at a time can be made using any given account number.
?? If a Net2Phone account number is entered for an FXO port in the Account Configuration
Table, the account entered acts as a “default” account for the port. Charges incurred by
callers through that port automatically accrue to this account.
?? Whenever a selection in the Login column is modified, the MAX must be restarted before
the change will take effect.
4.3.2 Multiple Account Management
For multiple account management:
1. For each port that is connected to a telephone or PBX/KPS, enter the account number and
PIN you intend to use with that port.
2. Make sure that Use account for all ports is NOT checked.
4. After the desired changes have been entered, click the Save button to save them.
5. Click the Restart System link on the Site Map page to reboot the system.
4.3.3 The Login Button
The Yes radio buttons in the Login column (Figure 20, above) are used to enable a port to
receive incoming MAX-to-MAX calls. This topic is discussed in Section 4.4.2.1,Configuring
MAX-to-MAX Calling.
Net2Phone MAX 410/420/430 User Guide Section 4.3 – Configuring Accounts
To Next Page
Loading...