Page 20
The IP Configuration table displays all the Net2Phone MAX 410/420/430’s IP-related parameters.
The Voice Configuration table displays the Jitter Buffer Bounds, which are used to control Quality of
Service (QoS). The upper and lower bounds can be changed; larger bounds produce less packet
loss, while smaller bounds produce more packet loss. However, packet delay increases with the
bounds size. The default values in this table should not normally be changed.
DHCP users: If your LAN is using DHCP addresses, you do not have to configure this page. You
may proceed directly to Configuring Accounts, below.
Static address users: Your IP address and netmask are already present in the IP Configuration
table (you entered them previously). Now you need to enter the additional IP parameter information
you obtained from your LAN administrator:
?? Default Gateway
?? DNS Server IP (Primary)
?? DNS Server IP (Secondary)
?? Domain Name (if applicable)
NOTE: If a default gateway address or a DNS server address is not used, the value 0.0.0.0 must be
entered into their respective boxes. If the boxes are left blank, the modified configuration settings will
not be saved.
The Network Configuration table displays the doorman IP addresses and ports, and the TCP/UDP
start ports.
The Port Numbers parameters must be changed to permit access when a LAN’s firewall permits only
pre-assigned TCP/UDP port numbers to be used.
Reminder: Configuration changes you make in the MAX 410/420/430 are not applied until you reset
the unit. To do this, you may either:
?? go to the Restart System page (Section 4.7.3, below) and click Restart,
?? type /system/reset at the command prompt, or
?? power-off the unit, wait 10 seconds, and turn it on again.
Net2Phone MAX 410/420/430 User Guide Section 4.1 – Network and Voice Configuration
To Next Page
Loading...