NETGEAR FVS124G User Manual

Introduction
This document describes how VPN Tracker can be used to establish a connection between a
Mac running Mac OS X and a NETGEAR VPN gateway.
NETGEAR Configuration
The first part of this document will show you how to configure a VPN tunnel on a NETGEAR VPN router using a basic
VPN setup that can accept incoming connections from any IP address.
VPN Tracker Configuration
In the second part, this document will show you how to configure VPN Tracker to easily connect to your newly created
VPN tunnel.
Troubleshooting and Advanced Topics
Troubleshooting and advanced topics are covered in the third part of this document. There you will find:
‣
instructions for setting up a VPN connection for multiple users
‣
troubleshooting tips
‣
an in-depth discussion of the various NETGEAR settings and how they relate to VPN Tracker
4
Note This documentation is only a supplement to, not a replacement for, the instructions included with your NETGEAR
device. Please be sure to read those instructions and understand them before starting.

NETGEAR FVS124G Specifications

Power

power requirements	12V DC, 1.2A

System Memory

processor	200 MHz 32-bit RISC
memory	4MB Flash, 16MB DRAM

Ports & Interfaces

LAN ports	Four (4) 10/100/1000 Mbps auto-sensing, AutoUplink RJ-45 ports
WAN ports	Two (2) 10/100Mbps Ethernet RJ-45 ports

Weight and Dimensions

dimensions	7.45 x 4.85 x 1.26 in. (18.92 x 12.31 x 3.19 cm)
weight	1.37 lbs. (0.62 kg)