NETGEAR FVS124G User Manual

Step 2 –"Retrieve your NETGEAR’s LAN and WAN Configuration
(*) If you are using a subnet mask with elements that are not 0 or 255, you can
use one of the many subnet calculators available for free on the Internet to
calculate the network address.!
11
00:00:00
1
2
00:00:00
➍
➏
➎
‣
Go to Maintenance > Router Status and obtain the
following information from the Router Status page:
‣
WAN1 Configuration:
‣
Write down the WAN IP Address ➍
‣
If you use Dynamic DNS for your device, or if it has a
DNS host name, write down the host name instead
‣
LAN Port:
‣
Write down the LAN IP Address ➎
‣
Write down the LAN IP Subnet Mask ➏
‣
Calculate your LAN Network Address by applying the LAN
Subnet Mask ➏ to the LAN IP Address ➎:
‣
Applying the subnet mask means setting those elements of
the IP address to 0 where the subnet mask is 0, and
preserving all elements where the subnet mask is 255 (*)
‣
In our example:
‣
Write down the LAN Network Address you have
calculated as ➐
192 168 13 1
255 255 0255. . .
. . .
LAN Subnet Mask
LAN IP Address
applied to
LAN Network Address 192 168 13 0
. . .

NETGEAR FVS124G Specifications

Power

power requirements	12V DC, 1.2A

System Memory

processor	200 MHz 32-bit RISC
memory	4MB Flash, 16MB DRAM

Ports & Interfaces

LAN ports	Four (4) 10/100/1000 Mbps auto-sensing, AutoUplink RJ-45 ports
WAN ports	Two (2) 10/100Mbps Ethernet RJ-45 ports

Weight and Dimensions

dimensions	7.45 x 4.85 x 1.26 in. (18.92 x 12.31 x 3.19 cm)
weight	1.37 lbs. (0.62 kg)