NETGEAR FVS124G User Manual

Task 1 – Configure your NETGEAR
This section describes how to set up your NETGEAR’s VPN. If you do not yet have VPN
configured and in use on your device, please proceed exactly as described in this section. We
will first be creating an IKE policy, which corresponds to “Phase 1” in VPN Tracker. In a second
step, we will be setting up an associated VPN (IPsec) policy, which corresponds to “Phase 2” in
VPN Tracker.
9
Advanced Users If you already have VPN in use on your device, you can use this chapter to verify your settings (refer
to the chapter “VPN Settings Explained” for more detailed information about the settings available on
your NETGEAR). If you have multiple VPN policies set up on the device, you will have to ensure that
there are no unintended side-effects. Please read the chapter “Supporting Multiple Users“ to learn
how to set up multiple tunnels without them interfering with each other.
‣
Go to VPN > IKE Policies
‣
Click “Add”
Note Make sure you have a current backup of your NETGEAR’s configuration before making any changes.
Step 1 – Create a new IKE policy

NETGEAR FVS124G Specifications

Power

power requirements	12V DC, 1.2A

System Memory

processor	200 MHz 32-bit RISC
memory	4MB Flash, 16MB DRAM

Ports & Interfaces

LAN ports	Four (4) 10/100/1000 Mbps auto-sensing, AutoUplink RJ-45 ports
WAN ports	Two (2) 10/100Mbps Ethernet RJ-45 ports

Weight and Dimensions

dimensions	7.45 x 4.85 x 1.26 in. (18.92 x 12.31 x 3.19 cm)
weight	1.37 lbs. (0.62 kg)