NETGEAR FVS124G - Task 2 - Configure VPN Tracker; Step 1 - Create a New Connection

Task 2 – Configure VPN Tracker
This section describes how to configure VPN Tracker to connect to your NETGEAR. You will
need the configuration information you collected during Task 1. If you are missing any
information, please refer back to “Task 1 – Configure your NETGEAR”.
Step 1 - Create a New Connection
14
‣
Start VPN Tracker
‣
Click the “+” button at the bottom of the
connection list
You will be asked to select a device profile for the
new connection:
‣
Select “Netgear” from the list
‣
Select your device from the list of NETGEAR
devices
‣
If your device has more than one device or
firmware revision available, be sure to select the
revision/firmware matching your device
‣
Connection Name: Choose a name for your
connection (e.g. “Office”)
‣
Click “OK”