NETGEAR GC110 Hardware Installation Guide

Features
The switch includes the following key hardware features:
•
Eight Gigabit Ethernet ports.
•
Two dedicated Gigabit SFP fiber ports.
•
PoE on copper ports (model GC110P):
-
Eight ports PoE (IEEE 802.3af)
-
Total PoE power budget of 62W
•
MAC table size of 16K entries.
•
Switch fabric full duplex nonblocking.
•
Includes the following mounting hardware:
-
Four rubber footpads for tabletop installation
-
Wall-mount screw kit for wall installation
•
Full compatibility with IEEE standards:
- IEEE 802.3 Ethernet
- IEEE 802.3u 100BASE-T
- IEEE 802.3ab 1000BASE-T
- IEEE 802.3z Gigabit Ethernet 1000BASE-SX/LX
- IEEE 802.1Q VLAN tagging
-
IEEE 802.3x Full-duplex flow control
- IEEE 802.3ad Link aggregation (LAG with LACP)
- IEEE 802.1ab LLDP
-
IEEE 802.1p Class of Service (QoS)
- IEEE 802.1D Spanning Tree Protocol (STP)
- IEEE 802.1s Multiple Spanning Tree Protocol (MSTP)
- IEEE 802.1w Rapid Spanning Tree Protocol (RSTP)
- IEEE 802.1x RADIUS network access control
-
IEEE 802.3az Energy Efficient Ethernet (EEE)
-
IEEE 802.3af (PoE)
Hardware Installation Guide8Introduction
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries