NETGEAR GC110 Hardware Installation Guide

Name: NETGEAR GC110
Brand: NETGEAR
Rating: 5 (1 reviews)

38 pages

To Next Page

To Previous Page

Installation

This chapter describes the installation procedures for the switch. Switch installation

involves the steps described in the following sections:

• Step 1: Prepare the site

• Step 2: Protect against electrostatic discharge

• Step 3: Unpack the switch

• Step 4: Install the switch

• Optional Step 5: Install SFP transceiver modules

• Step 6: Connect devices to the switch

• Step 7: Check the installation

• Step 8: Apply power and check the LEDs

• Step 9: Manage the switch

Other manuals for NETGEAR GC110

Need help?

Do you have a question about the NETGEAR GC110 and is the answer not in the manual?

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries