NETGEAR GS724T User Manual

Ethernet Audio Video
18
GS716T and GS724T Gigabit Smart Switches
To display the 802.1AS Configuration page click the Switching tab, then click 802.1AS >
Basic > 802.1AS Configuration.
\
To configure the global 802.1AS settings on the switch:
1. Enable or disable 802.1AS globally on the switch. The default mode is Enable.
2. Configure the Priority1 value of the local clock (this time-aware bridge).
3. Configure the Priority2 value of the local clock (this time-aware bridge).
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
5. If you make any changes to the page, click Apply to retain the changes to the system.
The following table shows the non-configurable information on the 802.1AS Configuration
page.
Table 1-1.
Field Description
GrandMaster Present Identifies whether Grand Master Clock is present. The default is False.
Best Clock Identity Shows the Best Clock Identity detected by this time-aware bridge.
Best Clock Priority1 Shows the Priority1 value of the best clock on the switch.
Best Clock Priority2 Shows the Priority2 value of the best clock on the switch.

NETGEAR GS724T Specifications

General

MAC address table	8000 entries
Jumbo frames support	Yes
Packet buffer memory	0.5 MB
Maximum data transfer rate	1 Gbit/s
Dimensions (WxDxH)	43 x 440 x 260 mm
Connectivity technology	Wired
Non-operating relative humidity (non-condensing)	0 - 95 %
Networking standards	IEEE 802.3, IEEE 802.3ab, IEEE 802.3u, IEEE 802.3x
Mean time between failures (MTBF)	59524 h
Power consumption (typical)	40 W
Storage temperature (T-T)	-10 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	0 - 90 %
SFP/SFP+ slots quantity	2
Basic switching RJ-45 Ethernet ports quantity	24
DHCP features	DHCP client
Switch type	Managed
Stackable	No

Weight and Dimensions

Weight	3200 g