GS700TS Smart Switch Software Administration Manual
Configuring Switching Settings 4-44
v1.0, June 2009
To configure Basic IGMP Snooping:
1. Click Switching > Multicast > Basic > IGMP Snooping Configuration.
The Basic IGMP
Snooping Configuration screen displays:
The Basic IGMP Snooping Configuration screen contains the following fields:
IGMP Snooping Configuration
• IGMP Snooping Status – Select the IGMP Snooping status on the device. The possible
field values are:
– Disable – Disables IGMP Snooping on the device. This is the default value.
– Enable – Enables IGMP Snooping on the device.
Interface Settings
• VLAN ID – Displays the VLAN ID.
• Status – Select the IGMP Snooping status on the VLAN. The possible field values are:
– Enable – Enables IGMP Snooping on the VLAN.
– Disable – Disables IGMP Snooping on the VLAN.
2. Select the IGMP Snooping Status in the provided field.
3. Click APPLY to update the device.
To configure IGMP Snooping on a VLAN:
1. Click Switching > Multicast > Basic > IGMP Snooping Configuration.
The Basic IGMP
Snooping Configuration screen displays.
Figure 4-27
To Next Page
Loading...
