NETGEAR GS724TS - ProSafe 24 Port Gigabit Stackable Smart Switch User Manual

GS700TS Smart Switch Software Administration Manual
1-5 Getting Started with Switch Management
v1.0, June 2009
Network without a DHCP Server
This section describes how to set up your switch in a network without a DHCP server, and is
divided into the following tasks:
• Manually assign network parameters for your switch
• Configure the NIC settings on the host PC
• Log in to the web-based switch management utility
Manually Assigning Network Parameters
If your network has no DHCP service, you must assign a static IP address to your switch. You can
also assign the switch a static IP address even if your network has DHCP service. Proceed as
follows:
1. Connect the GS700TS Gigabit Stackable Smart Switch to your existing network.
2. Power on the switch by plugging in the AC-DC power adapter. The default IP is
192.168.0.239.
3. Install the SmartWizard Discovery utility on your computer. The SmartWizard Discovery
utility is located on the switch installation CD.
4. Start the SmartWizard Discovery utility.
5. Click Discover for the SmartWizard Discovery utility to find your GS700TS Gigabit
Stackable Smart Switch. You should see a screen similar to that shown in Figure 1-1.
6. Click Configuration Setting. A screen similar to that shown below appears.

NETGEAR GS724TS - ProSafe 24 Port Gigabit Stackable Smart Switch Specifications

General

Brand	NETGEAR
Model	GS724TS - ProSafe 24 Port Gigabit Stackable Smart Switch
Category	Switch
Language	English