GS700TS Smart Switch Software Administration Manual
Managing Security 6-31
v1.0, June 2009
• Source IP Address – Enter the source IP Address.
• Prefix Length – Enter the source IP Prefix Length. The Prefix field is applicable only
when the IPV6 Static IP address is defined as a Global IPv6 address. The range is 5 - 128.
• Destination IP Address – Enter the destination IP address.
• Prefix Length – Enter the destination IP Prefix Length. The Prefix field is applicable only
when the IPV6 Static IP address is defined as a Global IPv6 address. The range is 5 - 128.
• Source Port – Enter the source port that is matched to packets.
• Destination Port – Enter the destination port that is matched to packets.
• DSCP – Match the packet DSCP value to the ACL. Either the DSCP value or the IP
Precedence value is used to match packets to ACLs. The possible field range is 0-63.
• IP Prec. – Match the packet IP Precedence value to the ACL.
• Action – Select the action applied to packets with IP addresses that have been filtered. The
possible field values are:
– Permit – Permits access to the device.
– Deny – Denies access to packets originating from the blocked IP address.
– Shutdown – Drops packets that meet the ACL criteria, and disable the port to which
the packet was addressed.
2. Select the ACL Name from the list in the provided field.
3. Select the rule entry.
4. Enter the provided fields in the first row.
5. Click APPLY to update the device.
To add an IPv6 rule:
1. Click Security > ACL > IPv6 Rules. The IPv6 Rules screen displays.
2. Select the ACL Name from the list in the provided field.
3. Click ADD to create a new entry or duplicate an existing entry.
4. Select the added entry.
5. Enter the provided fields in the first row.
6. Click APPLY to update the device.
To delete an IP rule:
To Next Page
Loading...
Need help?
General