GS700TS Smart Switch Software Administration Manual
Monitoring the Switch 7-24
v1.0, June 2009
• Type – Select the port mode configuration for port mirroring. The possible field values
are:
– TX Only – Indicates port mirroring is configured on transmitting ports only.
– RX Only – Indicates port mirroring is configured on receiving ports only.
– TX and RX – Indicates port mirroring is configured on both receiving and
transmitting ports. This is the default value.
2. Enter the Destination Port in the provided field.
3. Select the source port entry.
4. Select the port mirroring Type from the list in the provided field in the first row.
5. Click APPLY to update the device.
To add a source port entry:
1. Click Monitoring > Port Mirroring > Port Mirroring. The Port Mirroring screen displays.
2. Enter the Source Port in the provided field in the first row.
3. Select the port mirroring Type from the list in the provided field in the first row.
4. Click ADD to update the device.
To remove a source port entry:
1. Click Monitoring > Port Mirroring > Port Mirroring. The Port Mirroring screen displays.
2. Select the source port entry.
3. Click DELETE to remove the source port entry.
To Next Page
Loading...
