NETGEAR GS728TS Hardware Installation Guide

8 | Chapter 1. Introduction
GS728TS, GS728TPS, GS752TS, and GS752TPS Smart Switch Hardware Installation Guide
• 2 x SFP (slot) to support 1G optical module (uplink) or 2.5G stacking (via stacking
cable).
• GS728TPS/GS752TPS
• 24/48 PoE-capable 10/100/1000 Mbps copper ports (8 PoE+ capable)
• 2 x Combo ports to support 10/100/1000 Mbps copper ports or 1G/100M optical
module.
• 2 x SFP (slot) to support 1G optical module.
• 2 x SFP (slot) to support 1G optical module (uplink) or 2.5G stacking (via stacking
cable).
• Stacking ports
• GS728TS/GS728TPS: Port 27 and port 28 can be used as the stacking ports or as
uplink ports.
• GS752TS/GS752TPS: Port 51 and port 52 can be used as the stacking ports or as
uplink ports.
• Six 100/1000Mbps SFP slots and two 2.5Gbps ports for stacking.
• Full NETGEAR Smart Switch functionality.
• Stack will support up to a maximum of 6 switches.
• Mix and match stacking supported on the GS7xxTS/GS7xxTPS family (GS728TS,
GS752TS, GS728TPS and GS752TPS).
• Full compatibility with IEEE standards:
• IEEE 802.3i (10BASE-T)
• IEEE 802.3u (100BASE-TX)
• IEEE 802.3ab (1000BASE-T)
• IEEE 802.3z (1000BASE-x)
• IEEE802.3az (Energy Efficient Ethernet)
• IEEE 802.3x (Full-duplex flow control)
• IEEE802.3af (DTE Power via MDI)
• IEEE802.3at (DTE Power via MDI Enhancements)
• PoE
• GS728TPS: Port 1-8 support both IEEE802.3 at and af, and port 9-24 support
IEEE802.3af.
• GS752TPS: Port 1-8 support both IEEE802.3 at and af, and port 9-48 support
IEEE802.3af.
• Autosensing and auto-negotiating capabilities for all ports.
• Auto Uplink™ on all ports to make the right connection.
• Automatic address learning function to build the packet-forwarding information table. The
table contains up to 16K Media Access Control (MAC) addresses.
• GS7xxTS Model LEDs: Port LED, Power and Status LED, FAN status LED and Master
LED.

NETGEAR GS728TS Specifications

General

Brand	NETGEAR
Model	GS728TS
Category	Switch
Language	English