NETGEAR N300

Virtual Private Networking
120
N300 Wireless ADSL2+ Modem Router DGN2200v3
9. The VPN Policies screen displays, showing that the new tunnel is enabled.
Note: See Use Auto Policy to Configure VPN Tunnels on page 125 for
information about how to enable the IKE kee
palive capability on an existing
VPN tunnel.
10. Repeat
these steps for the gateway on LAN B, and pay special attention to the following
network settings:
• W
AN IP of the remote VPN gateway (for example, 14.15.16.17)
• LAN IP settin
gs of the remote VPN gateway:
- IP a
ddress (for example, 192.168.0.1)
- Sub
net mask (for example, 255.255.255.0)
- Preshared
key (for example, 12345678)
11. Use
the VPN Status screen to activate the VPN tunnel by performing the following steps:
Note: The VPN Status screen is only one of three ways to active a VPN
tunnel. See
Activate a VPN Tunnel on page 121 for information
about the other ways.
a. Select Advanced > Advanced - VPN > VPN Status, and click the VPN Status button
to display the Current VPN Tunnels (SAs) screen:
b. Click Connect for the VPN tunnel you want to activate. View the VPN Status/Log
screen to verify that the tunnel is connected.