VPN Configuration
154
N300 Wireless ADSL2+ Modem Router DGN2200v3
Setting Up Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves two steps:
• Step 1: Configure Gateway A (Router at the Main Office) o
n page 154.
• Step 2: Configure Gateway B (Router at the Regional Office) on p
age 155 describes
configuring the NETGEAR ProSafe VPN Client endpoint.
Step 1: Configure Gateway A (Router at the Main Office)
1. Log in to the VPN router. Select VPN Policies to display the VPN Policies screen. Click
Add Auto Policy.
2. Enter the following information, based on your individual setup:
• Polic
y Name. In this example, from GW_A is used.
• IKE Keep Aliv
e: This is optional. It has to match the value in the Remote LAN IP
Address field when enabled. (The remote computer has to respond to pings.)
• Remote LAN. I
n this example, the IP address is 192.168.2.3. The remote NAT router
has to have address reservation set and VPN Passthrough enabled.
• IKE Loca
l Identity Type and Remote Identity Type. In this example, the fully
qualified domain names used are from GW_A.com and toGW_A.com.
To Next Page
Loading...
Need help?
General
