NETGEAR Nighthawk Pro XR1000 User Manual

You must use the power supply when you connect the USB storage device to the
router.
When you connect the USB storage device to the router’s port, it might take up to
two minutes before it is ready for sharing. By default, the USB storage device is
available to all computers on your local area network (LAN).
3. Select Start > Run.
4.
Enter \\readyshare in the dialog box.
5. Click the OK button.
A window automatically opens and displays the files and folders on the USB storage
device.
Map a USB device to a Windows network
drive
To map the USB storage device to a Windows network drive:
1. Connect a USB storage device to a USB port on your router.
2.
If your USB storage device uses a power supply, connect it.
You must use the power supply when you connect the USB storage device to the
router.
When you connect the USB storage device to the router’s port, it might take up to
two minutes before it is ready for sharing. By default, the USB storage device is
available to all computers on your local area network (LAN).
3. Select Start > Run.
4.
Enter \\readyshare in the dialog box.
5. Click the OK button.
A window automatically opens and displays the USB storage device.
6. Right-click the USB device and select Map network drive.
The Map Network Drive window opens.
7.
Select the drive letter to map to the new network folder.
8. Click the Finish button.
The USB storage device is mapped to the drive letter that you specified.
User Manual174Share USB Storage Devices
Attached to the Router
Nighthawk Pro Gaming Router Model XR1000

NETGEAR Nighthawk Pro XR1000 Specifications

General

WiFi Technology	WiFi 6 (802.11ax)
Processor	1.5GHz triple-core processor
Antenna	4 external antennas
USB Ports	1 x USB 3.0 port
RAM	512MB
Flash Memory	256MB
MU-MIMO	Yes
QoS	Dynamic QoS
WiFi Speed	AX5400 (5.4 Gbps)
Ethernet Ports	4 LAN @ 1G Mbps
Frequency Band	Dual-Band (2.4GHz + 5GHz)
Security	WPA3, VPN support