ProSafe
®
Plus Switch Configuration Utility User Guide
Getting Started 1-5
v1.0, February 2010
Discovering Switches
When the utility is launched, it immediately searches the network for ProSafe
®
Plus switches.
Note: Local PC firewall applications such as Symantec Endpoint Protection can prevent the utility from
communicating with the switches. If the utility is unable to discover your switches and you are using a
local firewall, you will need to turn off the firewall function in order for discovery to work.
Within a few seconds the utility will discover and list all ProSafe
®
Plus switches in your network or in the
same broadcast domain. Discovery will continue through the network until blocked by a router or firewall.
The discovered switches are displayed as shown below.
You can now select a switch to configure or display status.
Note: At this point you can select an alternate language for the Utility user interface. Click on the Select
Language pull down menu and click on the desired language. You will be asked to restart the Utility
to enable the selected language.
To Next Page
Loading...
Need help?
General