ProSafe
®
Plus Switch Configuration Utility User Guide
1-8 Getting Started
v1.0, February 2010
Default Settings
All of the ProSafe
®
Plus Switch features have default settings. You do not need to configure any settings in
order to use the ProSafe
®
Plus switches.
The following table lists the default values for switch settings. Shaded features are not configurable on all
switches.
Table 1-1. Feature Default Values
Tab Menu Feature Default Value
System
Status
Switch Selection No switch selected
Names All names blank
Passwords “password” for all switches
Switch Information
DHCP Mode Enabled
IP Address 192.168.0.239
Subnet Mask 255.255.255.0
Gateway Address 192.168.0.254
Maintenance
Change Password All fields blank
Device Reboot Unchecked
Factory Default Unchecked
Firmware Upgrade Filename blank
Monitoring
Port Statistics 0
Mirroring Disabled
Cable Tester OK or No Cable for each port
To Next Page
Loading...
Need help?
General