NetGear Print Server Manual
16
TCP/IP
The TCP/IP configuration screen is used to configure the IP address of the print server. Figure 3-3
shows the TCP/IP configuration screen and following table lists its fields, describes the functions, and
explains how to provide information in each field.
Figure 3-3 TCP/IP Configuration Screen
TCP/IP Configuration Fields
DHCP Client
This field allows you to enable or disable the print server's ability to get its IP address from a DHCP
(Dynamic Host Configuration Protocol) server. When disabled, you can provide a fixed IP address in the
following fields. If DHCP client is enabled, the fields that follow are not used.
IP Address
This IP address is assigned to the print server. If you have a private LAN and do not plan to connect to
the TCP/IP based internet, NETGEAR recommends that you use the address from the IETF-designated
private addresses (for example, 192.168.x.x or 10.x.x.x).
This subnet mask defines the range of addresses that are reachable on your local LAN. For example, in
a network with a NETGEAR router, the default subnet mask is usually 255.255.255.0.
Gateway
Address
This is the IP address of the router on your network. For example, in a network with a NETGEAR router,
the gateway address is usually 192.168.0.1.
Save
Cancel
Buttons
Save:
After the configuration, click on ‘Save’ button to save the value permanently to Print Server.
Cancel:
If changed something that is not good, click on ‘Cancel’ button will load the value back from the print
server. No modification will be made.
To Next Page
Loading...
Need help?
General
