NetGear Print Server Manual
30
4-2 NETGEAR Print Server Software Installation
NETGEAR Print Server software works for PS100 series Print Severs in a Microsoft Windows
networking environment.
To install and set up your network and the NETGEAR Print Server, you may use a PC with a
Microsoft Windows (95, 98, NT 4.0, ME, 2000, or XP) operating system and with either the TCP/IP
protocol or the NetBEUI protocol enabled.
1. Turn on the power to your PC.
Before proceeding with these instructions, be sure to assign a name to your
workgroup on your PC. NETGEAR strongly recommends that you exit all Windows
programs before running the Setup program. It is also necessary to install the
NETGEAR Print Server software on every PC in the network that will use the
printers attached to the PS100 series Print Sever.
Insert the CD ROM into the CDROM drive. The program should start automatically. If not, please
double click on setup.exe under the CDROM root directory. The first screen is shown below. Click
on Next button.
Figure 4-1 Print Server Installation
2. The second screen provides you an important message as shown below. Click on Next button.
To Next Page
Loading...
Need help?
General
