NetGear Print Server Manual
83
If the NetWare print server to which the NETGEAR print server will be connected has been previously
loaded, you must unload and reload it again. If you are unloading and reloading the PSERVER NetWare
Loadable Module (NLM), start with step a. If you are loading the NLM for the first time, go to step d.
To load the NetWare PSERVER module:
a. Go to the file server console where the PSERVER.NLM is running.
b. Press [Alt] + [Esc] until the print server NLM window opens.
c. Press [Esc] to stop the print server NLM and answer Yes.
d. Enter the following command when the NetWare NLM has been unloaded:
load pserver xxxx
xxxx is the same NetWare print server entered in steps 3 c and 6 f.
Your print server is now set up as a remote printer in the NetWare networking environment. You can
access the print server using NetWare commands printing to the designated queue or printer.
To Next Page
Loading...
