NetGear Print Server Manual
90
h. Press [Esc] to exit PCONSOLE.
3. Configure your print server.
To configure your print server:
a. Execute the PSCONFIG program while logged on to the file server.
b. Select the NETGEAR print server that you want to configure.
c. Select Change Configuration.
d. Select NetWare Configuration.
e. Verify that the Operation Mode is RP.
RP must be the operation mode for the print server to operate in RPRINTER mode. If the operation
mode is PS, the print server operates in PSERVER mode. It can operate in only one mode at a time.
f. Select and type the name of the NetWare print server in the Novell PSERVER (P1) entry field.
You can also modify the Novell PSERVER field of the other printer ports if they exist.
g. Press [Esc] to return to the Select Configuration Item window.
h. Select System Configuration if any changes to the print server name are necessary.
To change the print server name, Select Device Name, change the print server to the new name, and
then exit back to the Select Configuration Item window.
i. Select Execute Change.
j. Press [Enter] when asked if you are sure.
k. Press [Esc] when a window opens indicating that the configuration is complete.
l. Press [Esc] to return to the Active Device List main menu.
You can press F2 to make sure that the new print server name is activated, if it was changed.
m. Press [Esc] to exit the PSCONFIG program.
4. Load the PSERVER.NLM on the NetWare file server.
If the NetWare print server to which the NETGEAR print server will be connected has been previously
loaded, you must unload and reload it again. If unloading and reloading the PSERVER NetWare Loadable
Module (NLM), start with step a. If you are loading the NLM for the first time, go to step d.
To load the NetWare PSERVER module:
a. Go to the file server console where the PSERVER.NLM is running.
b. Press [Alt] + [Esc] until the print server NLM window opens.
To Next Page
Loading...
Need help?
General
