NETGEAR R6200 User Manual

Troubleshooting
112
Dual Band 11ac WiFi Router R6200
LEDs Never Turn Off
When the router is turned on, the LEDs turn on for about 10 seconds and then turn off. If all
the LEDs stay on, there is a fault within the router.
If all LEDs are still on 1 minute after power-up:
• Cycle the power to see if the router recovers.
• Press and hold the Reset button to return the router to its factory settings as explained in
Restore the Factory Settings and Password on page 117.
If the error persists, you might have a hardware problem. Contact technical support at
www.netgear.com/support.
Internet or Ethernet Port LEDs Are Off
If either the Ethernet port LEDs or the Internet LED does not light when the Ethernet
connection is made, check the following:
• Make sure that the Ethernet cable connections are secure at the router and at the modem
or computer.
• Make sure that power is turned on to the connected modem or computer
.
• Be sure that you are using the correct cable:
When connecting the router’s Internet port to a cable or DSL modem, use the cable that
was supplied with the cable or DSL modem.
This cable could be a standard
straight-through Ethernet cable or an Ethernet crossover cable.
Wireless LEDs Are Off
If the Wireless LEDs stay off, check to see if the Wireless On/Off button on the router has
been pressed. This button turns the wireless radios in the router on and off. The Wireless
LEDs are lit when the wireless radio is turned on.
The Push 'N' Connect (WPS) Button Blinks Amber
If after using the WPS function the button blinks amber, check the following:
• Make sure that you are using the button and not the router’
s built-in registrar.
• Check that PIN verification has succeeded for the wireless device you are adding to the
wireless network.
• Make sure that you have not pressed the WPS button on the side of the router after
disabling the WPS feature (you logged in to the router and disabled this previously).
• Check that the router is not in the temporary
AP setup locked state (if you are using the
wireless repeater function).

NETGEAR R6200 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet LAN interface type	Gigabit Ethernet
Wi-Fi standards	Wi-Fi 5 (802.11ac), 802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Top Wi-Fi standard	Wi-Fi 5 (802.11ac)
Bandwidth	2.4 GHz
Rack mounting	No
Ethernet LAN (RJ-45) ports	5
Web-based management	-
Security algorithms	WPA, WPA2-PSK, WPS
Flash memory	16 MB
Certification	RoHS, WEEE, CEC
Internal memory	128 MB
Windows operating systems supported	Windows 7 Home Premium, Windows 7 Home Premium x64, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows Vista Business, Windows Vista Business x64, Windows Vista Home Basic, Windows Vista Home Basic x64, Windows Vista Home Premium, Windows Vista Home Premium x64, Windows Vista Ultimate, Windows Vista Ultimate x64, Windows XP Home, Windows XP Home x64, Windows XP Professional, Windows XP Professional x64

Weight and Dimensions

Depth	77 mm
Width	205 mm
Height	255 mm
Weight	654 g