NETGEAR RP114

Reference Guide for the Model RP114 Web Safe Router
Troubleshooting 11-3
Note:
Recent versions of Windows and MacOS will generate and assign an IP address if the
computer cannot reach a DHCP server. These auto-generated addresses are in the range of
169.254.x.x. If your IP address is in this range, check the Ethernet connection from the PC to
the router and reboot your PC.
• Make sure your browser has Java, JavaScript, or ActiveX enabled. If you are using Internet
Explorer, click Refresh to be sure the Java applet is loaded.
• Make sure you are using the correct login information. The factory default login name is
“admin” and the password is “1234”. Make sure that CAPS LOCK is off when entering this
information.
• Try quitting the browser and launching it again.
• If your router’s IP address has been changed and you don’t know the current IP address, clear
the router’s configuration to factory defaults. This will set the router’s IP address to
192.168.0.1.
If the router does not save changes you have made in the Web Configuration Interface, check the
following:
• When entering configuration settings, be sure to click the APPLY button before moving to
another menu or tab, or your changes are lost.
• Click the Refresh or Reload button in the Web browser. The changes may have occurred, but
the Web browser may be caching the old configuration.
Troubleshooting the ISP Connection
If your router is unable to access the Internet, you should first determine whether the router is able
to obtain a WAN IP address from the ISP. Unless you have been assigned a static IP address, your
router must request an IP address from the ISP. You can determine whether the request was
successful using either the browser interface or the Manager interface.
To check the WAN IP address from the browser interface:
1.
Launch your browser and select an external site such as www.netgear.com
2.
Access the Main Menu of the router’s configuration at http://192.168.0.1
3.
Under the Advanced heading, click on Maintenance
4.
Check that an IP address is shown for the WAN Port
If 0.0.0.0 is shown, your router has not obtained an IP address from your ISP.