NETGEAR RP114

Reference Guide for the Model RP114 Web Safe Router
8-8 Using the Manager Interface to Configure the Router for Internet Access
Editing Filter Sets
You can apply filters to incoming or outgoing data in a Remote Node connection and also use
filters to cause or prevent the placement of outgoing calls to the Remote Node. To use filters, start
by defining the filters using Menu 21 - Filter Set Configuration as shown in Figure 8-4.
Figure 8-4. Menu 21 - Filter Set Configuration
Menu 21 - Filter Set Configuration
Filter Filter
Set # Comments Set # Comments
------ ----------------- ------ -----------------
1
NetBIOS_WAN
7 _______________
2 NetBIOS_LAN 8 _______________
3 TEL_FTP_WEB_WAN 9 _______________
4 _______________ 10 _______________
5 _______________ 11 _______________
6 _______________ 12 _______________
Enter Filter Set Number to Configure= 0