NETGEAR RP114

Reference Guide for the Model RP114 Web Safe Router
1-2 Introduction
– Powerful packet filtering capabilities
– Incoming port forwarding and DMZ for specific services
• Built in 4-port 10/100 Mbps Switch
– Allows LAN connections at 10 megabits per second (Mbps) or 100 Mbps
– Autosensing for Ethernet (10BASE-T) or Fast Ethernet (100BASE-Tx) transmissions
– Autosensing MDI/MDIX configures each port for normal or uplink connection
– Half-duplex or full-duplex operation
• Ethernet connection to a wide area network (WAN) device, such as a cable modem or DSL
modem
– RJ-45 interface allowing connection to a 10BASE-T device
• Protocol Support
–IP routing
– Dynamic extended Network Address Translation (NAT+) with port forwarding for
operation with a single static or dynamic IP address
– Dynamic Host Configuration Protocol (DHCP) server for dynamically assigning
network configuration information to PCs on the LAN
– DHCP client for dynamically obtaining configuration information from the Internet
Service Provider (ISP)
– DNS Proxy for simplified configuration
– PPP over Ethernet (PPPoE) support
• Login capability
– Automatically executes user login for RoadRunner cable modem service or PPP over
Ethernet accounts
• Easy installation and management
– Easy, web-based setup for configuration of most features
– Built-in Manager interface for configuration of advanced features, accessible by
Telnet Protocol
• Front panel LEDs for easy monitoring of status and activity
• Flash EPROM for firmware upgrade
• Five-year warranty, one year on power adapter