Reference Guide for the Model RP114 Web Safe Router
Basic Configuration of the Router 4-5
8.
Click on Next to go to the ISP Parameters screen, shown in Figure 4-4 below:
Figure 4-4. Browser-based Setup Wizard, second screen
This screen determines whether a login program will be run.
a.
If your service provider does not require a login program, leave Encapsulation as Ethernet
and proceed to Step 9.
b.
If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as PPPoE,
and enter these additional parameters:
• If your connection supports multiple ISPs, enter the Service Name of the one you use.
Otherwise leave Service Name blank.
• Enter the PPPoE login user name and password provided by your ISP. These fields are
case sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
Proceed to Step 9.
c.
(Europe) If your service provider uses Alcatel's ANT (ADSL Network Termination) with
PPTP as a login method, select Encapsulation as PPTP, and enter these additional
parameters:
• Enter the PPTP login user name and password provided by your ISP. These fields are
case sensitive.
• If you wish to change the login timeout, enter a new value in seconds.
To Next Page
Loading...
