User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Introduction 2-5
202-10041-01 September 2004
Connect to the
Internet over my
wireless
network.
1. An active Internet
connection like those from
cable or DSL service
providers.
2. A wireless network
connected to an Internet
service through a router as
illustrated in “Connecting
to an Access Point in
Infrastructure Mode” on
page 4-4.
3. TCP/IP Internet networking
software installed and
configured on my notebook
PC according to the
requirements of the
Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
1. Activate my
wireless link and
verify my network
connection.
2. Open an Internet
browser such as
Internet Explorer
or Netscape
Navigator.
To configure your WAG511 in
Infrastructure Mode, see “Basic
Installation Instructions” on
page 3-4, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see “Preparing Your
Computers for TCP/IP
Networking” on page C-1 or refer
to the PC Networking Tutorial on
the NETGEAR Dual Band
Wireless PC Card 32-bit
CardBus WAG511 Resource CD
and the Help information
provided in the Windows system
you are using.
.
Table 2-1. A Road Map for How to Get There From Here
If I Want To? What’s Needed? What Do I Do? How Do I?
To Next Page
Loading...
Need help?
General
