User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
3-4 Basic Setup
202-10041-01 September 2004
Basic Installation Instructions
Use the procedure below that corresponds to the version of Windows you are using.
For Windows XP Users Installing a WAG511
Install the WAG511 driver and
configuration utility software.
a. Power on your notebook, let the
operating system boot up completely,
and log in as needed.
b. Insert the Resource CD for the WAG511
into your CD-ROM drive. The CD main
page shown at the right will load.
c. Click Install Driver and Utility.
d. Follow the InstallShield Wizard steps,
and click Finish when done to restart
your computer.
WAG511 Resource CD
InstallShield Wizard
Note: If a Windows XP Certification warning
appears, click Continue Anyway to proceed.
To Next Page
Loading...
Need help?
General
