User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Wireless Security Configuration 5-7
202-10041-01 September 2004
WPA Security Settings Worksheet
Print this form, fill in the configuration parameters and put it in a safe place for possible future
reference. For an existing wireless network, the person who set up the network will be able to
provide this information.
• Wireless Network Name (SSID)
The Service Set Identification (SSID) identifies the wireless local area network.
Note
: Some wireless access points will not broadcast their SSID as a security feature. In such
a case, you will need to get the SSID from the wireless network administrator.
Wireless network name (SSID): ______________________________
• WPA EAP Settings
— TLS
• Certificate: ___________________________________________________________
• CA Server: ___________________________________________________________
For example, CA Server: Netgear Https
• Domain Name: ___________________ Login Name: _________________
For example, Domain Name: netgear.com Login Name: webmaster@netgear.com
— PEAP
• CA Server: ___________________________________________________________
For example, CA Server: Netgear Https
• Domain Name: ___________________ Login Name: _________________
For example, Domain Name: netgear.com Login Name: webmaster@netgear.com
• User Name: ________________ Password: ________________
For example, Windows User Name: netgeckoPassword: likesbugs
Note: While the User Name and Password in this example is the same as the Windows
User Name and Password (administered through the Windows Domain controllers or
the Windows Active Directory), the User Name and Password in a UNIX network
might be the LDAP credentials for this user, or the User Name and Password could
simply be the credentials stored in the RADIUS server.
Use the procedures below to configure WPA Advanced security settings in the WAG511.
To Next Page
Loading...
Need help?
General
