User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
5-4 Wireless Security Configuration
202-10041-01 September 2004
How to Configure WEP Encryption Security
Follow the steps below to configure WEP Encryption Security.
1. Run the WAG511 Smart Wireless Wizard.
a. Make sure the WAG511 software is installed and the WAG511 is fully inserted in your PC.
b. Open the configuration utility by clicking on the WAG511 icon on the Windows
desktop or in the system tray. The Settings tab page opens.
2. Configure the Network Name (SSID) settings.
Enter the SSID. This is also called the Wireless Network Name.
Tip: Click the Networks tab to view a list of the available wireless networks and their SSIDs.
3. Configure the WEP settings.
a. Select the WEP radio button.
Figure 5-1: WEP settings screen
To Next Page
Loading...
