User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
4-4 Configuration
202-10041-01 September 2004
Connecting to an Access Point in Infrastructure Mode
Figure 4-2: WAG511 Wireless PC Card connecting to a wireless access point.
This section provides instructions for configuring the NETGEAR Dual Band Wireless PC Card
32-bit CardBus WAG511 to connect to a wireless access point.
How to Configure an Infrastructure Mode Profile
Use these instructions to configure infrastructure mode profiles for connecting to access points.
1. Run the WAG511 Smart Wireless Wizard.
a. Make sure the WAG511 software is installed and the WAG511 is fully inserted in an
available CardBus slot in your PC.
b. Open the configuration utility by clicking on the WAG511 icon on the Windows
desktop or in the system tray. The Settings tab page opens.
To Next Page
Loading...
