User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Basic Setup 3-5
202-10041-01 September 2004
Insert the NETGEAR Dual Band Wireless
PC Card 32-bit CardBus WAG511.
a. Locate an available CardBus slot on the
side of your notebook. Hold the PC Card
with the NETGEAR logo facing up and
insert it into the CardBus slot.
After a short delay, the Found New
Hardware Wizard displays.
Follow the prompts to complete the
wizard.
b. Next you will be prompted to enable the
NETGEAR Smart Wireless Settings
Utility configuration utility.
Click Yes to accept this option.
If you choose No, you must read the
Windows XP documentation for an
explanation of how to use the Windows
XP wireless network configuration
utility
You will also be prompted to choose the
country you are located in. Select your
location from the list.
c. Click Finish to complete the installation.
You will see the WAG511 system tray
icon on the lower right portion of the
Windows task bar.
Found New Hardware Wizard
Note: Click Continue Anyway if you are
prompted with a Windows XP Logo
testing message.
Enable NETGEAR Utility Configuration
WAG511 System Tray Icon
To Next Page
Loading...
Need help?
General
