User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Basic Setup 3-7
202-10041-01 September 2004
Verify wireless connectivity to your network.
a. Verify that your Connection and Status Monitor information matches your wireless
network.
b. Check the two LEDs on the WAG511:
c. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation section of
the Reference Manual on the NETGEAR Dual Band Wireless PC Card 32-bit CardBus
WAG511 Resource CD.
LED 1
LED 2
Table 3-1: LED Descriptions
LED 1 LED 2 Meaning
Slow blink OFF Power save mode (default from power up or reset)
Alternate
blink
Alternate
blink
Looking for network association
Power LED goes ON; Network LED is OFF; then Power
LED goes OFF and Network LED goes ON
Slow blink Slow blink Associated or joined with network; no activity
Fast blink Fast blink Associated or joined with network; blink rate increases
with activity on the network over the air or locally on the
network
OFF OFF No power applied to the card
To Next Page
Loading...
Need help?
General
