User’s Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Basic Setup 3-9
202-10041-01 September 2004
Insert the NETGEAR Dual Band Wireless
PC Card 32-bit CardBus WAG511.
a. Locate an available CardBus slot on the
side of your notebook. Hold the PC Card
with the NETFGEAR logo facing up and
insert it into the CardBus slot.
After a short delay, the Found New
Hardware Wizard displays.
b. Follow the Found New Hardware
Wizard steps, click Finish when done,
and if prompted, restart your computer.
c. Next, you will be prompted to choose the
country where you are located. Select
your location from the list.
You should see the WAG511 system tray
icon on the right in the lower right
portion of the Windows task bar and on
the Windows desktop.
Found New Hardware Wizard
Note: If Windows warns about a Digital
Signature Not Found, click Yes to continue.
WAG511 System Tray Icon
To Next Page
Loading...
Need help?
General
