NETGEAR WGX102 User Manual

Reference Manual for the 54 Mbps Wall-Plugged Wireless Range Extender WGX102
Advanced Configuration of the WGX102 8-9
September 2004 202-10042-01
Configuring the LAN IP Setup Options in Router Mode
LAN IP Setup is under the Advanced heading on both the Access Point Mode and Router Mode
menus. If you are using the WGX102 in Access Point Mode, see “Configuring the LAN IP Setup
Options in Access Point Mode” on page 3-10 for configuration information.
This menu allows configuration of LAN IP services such as DHCP and RIP in Router Mode. From
the main menu of the browser interface, under Advanced, click LAN IP Setup to view the LAN IP
Setup menu, shown below.
Figure 8-6: LAN IP Setup menu in Router Mode
The range extender’s default LAN IP configuration is:
• LAN IP addresses—192.168.0.101
• Subnet mask—255.255.255.0
These addresses are part of the IETF-designated private address range for use in private networks,
and should be suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in this menu.

NETGEAR WGX102 Specifications

Weight and Dimensions

dimensions	3 x 8.6 x 6.5 in, 75 x 220 x166 mm
weight	2.0 lb